ADS-B traffic explained - Welcome aviators.

Portable ADS-B receivers for the iPad (like the Garmin GDL 50 and the Stratus 3) can receive ADS-B traffic in addition to weather. But unlike weather, which is broadcast continuously, traffic is only transmitted in response to specific prompts. This can make ADS-B traffic very confusing – when does it work and when doesn’t it work?

To help, we’ve created this series of graphics, which shows three common scenarios:

Graphic 1: The worst scenario, where you are flying with a portable ADS-B receiver, but do not have an ADS-B Out transponder installed in your panel. Here, you’ll receive any airplane that is transmitting ADS-B Out via air-to-air (no ground station required). many airplanes do not have ADS-B Out, so this is fairly limited. You will not see regular, Mode C targets.

Graphic 2: In this case, you are still flying with a portable ADS-B receiver and no ADS-B Out in your airplane, but you are close to another aircraft that is ADS-B Out equipped. In this case, that ADS-B Out airplane is waking up the ground station and is receiving a custom traffic picture for a 30-mile “hockey puck” around that airplane. If you are close enough to that airplane, your portable receiver can listen in on that traffic message. While you won’t get a complete traffic picture, you will get a better one, since the ground station transmits Mode C targets in addition to ADS-B targets. Just remember that you don’t know what you don’t know – there could be a target just outside the hockey puck that’s not showing up.

Graphic 3: This is the best possible case. You have an ADS-B Out transponder in your airplane, so you are transmitting out to the ground stations and creating your own “hockey puck” of traffic information. You’ll see all traffic within a 30 mile diameter and +/- 3500 ft.